Fixes an issue where when "Duplicate Scenes" and "Switch Preview/Program
after Transitioning" were disabled and preview and program were the same
scene, pressing "Transition" would just disable the menus without
anything happening. This is because a transition is initiated, but never
actually starts transitioning (since both scenes are the same). The
check for this already exists, but was only triggered in swapScenesMode.
Also renames the newScene variable to lastScene to make it more obvious
what it actually is (especially since now, it's not only the new scene
anymore).
The *AutoRelease helpers should not take references from OBSRef objects.
Instead, make an OBSRefAutoRelease base class, and OBSRef a subclass of
that to allow moves, and then perform moves from those objects.
This fixes an issue where *AutoRelease OBSRef objects would cause an
unintended double release of objects after having been assigned values
from non-*AutoRelease OBSRef objects.
If the fade to black was active and the user switched scene collections,
or exited studio mode, the source wouldn't be cleared, causing the
transition not to work properly when used again.
When setting the current scene and if it was the same as the previous,
the log would be spammed with switching scene messages.
This issue particularly happened when using undo/redo, as their
functions were setting the current scene.
This reverts commit 36ab7b97cff3bad9f3056b2f3cb1fa6a7158f79b.
The fact that a transition is a composition of two scenes was not
factored into the merging of this PR. Thus, it would apply to the
underlying scenes when transitioning, making the effectiveness of this
feature cause inconsistent rendering of the underlying scenes when
transitions are activated versus when they're not.
New profile state is similar to first start: settings are wiped, encoders
not setup. It may make sense to show the auto configuration wizard when
a new profile is made as well.
There is a checkbox option to show the wizard. If a profile is created
with the checkbox off, the checkbox will remain defaulted to off next
prompt.
When deleting a transition, it would sometimes select the one that
replaces it, which could be the separator. This would cause undefined
behavior. This fixes it so that it selects either the one that replaces
it (if a valid one replaces it), or the transition at the bottom of the
known list and not the separator.
Instead of having "Add [transition]" at the top of the combo box
blocking out the values, move the add values to the bottom of the box
instead for slightly better UX.
Adds `obs_frontend_set_tbar_position` and `obs_frontend_release_tbar`,
which allow plugins and scripts to control the tbar in OBS.
This specific change is required for the `SetTBarPosition`
request to be added to obs-websocket.
